- Higher Power Efficiency:This solar sensor light adopts Monocrystalline silicon solar panel,with higher power efficiency,the energy conversion rate can be up to 21%(polycrystalline silicon solar panel only has 17%).It can be used even in cloudy or rainy days.
- Intelligent Sensor:Integrated the design of human body infrared sensor and light sensor,it will auto turn on dim light mode when in darkness or at night,and auto turn off when in daytime or bright area.It will enter into bright light mode when people come and stay for 30s after motion stops and then turn to dim light to save energy.
- Long Working Time:With 20pcs LED bulbs and its brightness is up to 400lm,built-in 1200mAh rechargeable 18650 lithium batteries,it only needs 8 hours to be fully charged and can last for 12 hours working time.It’s a perfect choice to be used in garden, fence, patio, deck, yard, driveway, stairs, outside wall etc.
- Waterproof and Durable:The circuit board is coated with 3-resisting lacquer,which is insulated,damp proof,shockproof,dust-proof,corrosion proof,anti-aging,anti- corona,anti-creeping.The back side of the solar light is sealed without hollow so it can effectively isolate the water and mist.
- Invisible Switch:The “on/off” hole was designed for waterproof reason. Just use the supplied key pin to insert the switch hole. When hearing the “click”, the lighting system is unlocked.
Super Bright 20 LED Lights
1.Solar panel: 0.55W
2.Li-ion battery: 3.7V 1200mAh
3.LED power: 0.2W, 5000K-5500K,20PCS, 22-24lm/PCS
4.Motion angle and distance: 120degrees, 10ft
6.Size: 5.31*3.94*1.97 inches
7.Working mode: Automatically turn bright
1.Unlock and activate the solar light
The internal battery is locked from factory for safety shipment, so users have to use supplied Key Pin to click the “on/off” Switch Hole and unlock the battery and lighting system.
2.How to Install the device?
Please use the supplied expansion pillar-hinge and screw to mount the device on pole or wall and anywhere outside you want for lighting.
3.Charging via solar panel
Please make sure that the product is installed southward so that it can receive good direct sunlight without any shelter.
4.Night sensor function
At night or in darkness, this light will turn bright once human movement is detected by the PIR motion sensor then auto turn dim light when no motion after 30 seconds.
Two steps easy to check whether the light can work or not.
1. Unlock the product, charging the light by direct sunlight around 8 hrs.
2. Cover the solar panel with your hand, if the light is on, the product is working.
If the solar light does not work out after arrival, please turn the button off and let it absorb the sunlight for 2-3 days and then have a check again. Durable & Waterproof Solar Lights Made of high-impact ABS material, this 20LEDs motion sensor lights is IP65 waterproof so it can withstand rain and other extreme weather conditions.
2 x Solar Motion Sensor Light
2 x Expansion pillar-hinge
2 x Key pin
4 x Screw